How To Fix Whirlpool Cabrio Dryer PF Error

Cabrio Dryer PF Error

Whirlpool Cabrio Dryer PF Error Explained

The whirlpool Cabrio dryer PF error means the main control has had a power failure from either a loss of voltage from the power supply or the board itself. Usually a power surge causes the PF error and is easily reset.

  1. You may also need to perform a whirlpool cabrio dryer reset by unplugging the dryer for five minutes, this will reset the main board and is the only form of a control reset you can do.
  2. Press the pause/cancel button to clear the error from the display and restart the cycle. If the error happens again check the fuse/breaker at the panel and make sure its not blown / tripped, you may need to replace them.
  3. If the breaker / fuse checks out ok in the panel check that the dryer cord is properly connected to the dryer terminal block and make sure the connections are tight. Look for any burned spots at the terminal and on the cord itself.
  4. If the cord is good and the terminal block looks good then check the wall plug for loose wiring  or bad contacts. If your home wiring is good, the cord is good and the dryer terminal block is good then the problem lies in the main control board and it will have to be replaced.

Replacement Control Board To Fix Cabrio Dryer PF Error

Control Board Replacement Instruction Video

Below is a whirlpool cabrio dryer control board instructional video that will show you how to replace the board.

If you have any questions or need any help with fixing your whirlpool cabrio dryer PF error then ask one of our factory trained technicians by clicking the live tech help button at the bottom right of your page.

This whirlpool cabrio dryer PF error repair information applies to all the models listed below in the tags section and many more.

Add a Comment

Your email address will not be published. Required fields are marked *