WHIRLPOOL CABRIO WASHER ERROR F3E2 EXPLAINED

Cabrio Washer Error F3E2

WHIRLPOOL CABRIO WASHER ERROR F3E2

The Cabrio Washer F3E2 error code means there is a inlet water temperature fault and is usually caused by a shorted or open inlet thermistor.

  1. In most cases you will just need to replace the water inlet valve assembly regardless of the fact its allowing water in the unit.
  2. In some cases it can be the main board causing the error and the board will have to be replaced. There are some diagnostics you can do to make sure its not the board if you have an ohm/volt meter.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F3E2 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F3E2 Repair Guide.

This error code applies to the models below in the tag section and many more.

Add a Comment

Your email address will not be published. Required fields are marked *