Cabrio Washer Error F6E2


The Cabrio Washer F6E2 error code means the user interface board cannot communicate with the main control board.

  1. Reset the washer by unplugging the washer for 5 minutes then plug it back in and see if the error persists. If the error quits and the washer is working after the reset then the main board just needed a hard reset.
  2. If the reset did not help then either there is a wiring issue between the user interface and the main board or either the user interface or main board has failed. There are some diagnostic steps you can take using an ohm/volt meter that can determine if the user interface has failed. If you need help with this error let us know.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F6E2 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F6E2 Repair Guide.

This error code applies to the models below in the tag section and many more.

Add a Comment

Your email address will not be published. Required fields are marked *