I am trying to replace the water inlet valve on my whirlpool washer and I’m finding it difficult to remove the control panel. Model #wtw7000gc2
Follow the directions below to remove the console on a Whirlpool Cabrio washer model WTW7000GC2.
1. Unplug the washer.
2. Turn off the water valves.
3. Remove the 2 1/4" hex-head mounting screws from the reaor of the console.
4. Slide the putty knife down between the console assembly
and top panel. Use your free hand to push back on the
top of the console while you flex and maneuver the putty
knife up and around the screw. This will release the conosle clip. Do that for both right and left side of conole, then the console will flip forward exposing the water valve.
If you need further information the full service manual for that model is attached below.
Your Answer
