Whirlpool Cabrio Washer Error PO
The Cabrio Washer PO error code stands for Pump Out which happens when the lid has been open for more than ten minutes with water in the tub so it automatically begins pumping the water out and the display shows PO.
- Just simply lower the lid to stop the drain pump from emptying the tub.
If you need the specific diagnostic steps to take for the Whirpool Cabrio Washer Error PO
then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error PO Repair Guide.This error code applies to the models below in the tag section and many more.
All of the lights come on around the wash selection knob it humms time doesn’t change pump doesn’t pump nothing but humming like the pump is running but not pumping water out and flashes PO
PO just means power outage which means the main control lost voltage at some point probably due to a power surge or something. Just hit the cancel/stop button and that should clear the error. If not The only thing you can do is try and reset the electronics by killing power to it at the breaker/fuse panel on your home for one full minute then restore power. If after that the problem persists and the error keeps occurring and there is proper voltage applied to the machine then the main control has failed. I can’t give you part information without the model number. IF you want the part number post a new question with your full model number and ask for the main control part number, thanks.