Frigidaire Affinity Washer Error E11
The Frigidaire Affinity Washer Error E11 is a long fill error, meaning it takes too long for the washer to fill with water to satisfy the primary control, so it’s shutting down the cycle and reporting the E11 error.
Frigidaire Affinity Washer Error E11 Troubleshooting
Step 1: Does the washer seem to be filling with water as fast as usual?
Yes: go to step 4.
No: go to step 2.
Step 2: Have you verified that the water supply is on and the washer is getting the proper water pressure?
Yes: go to step 3.
No: make sure the water is on, and there is water pressure.
Step 3: Is the incoming water pressure above (30) psi?
Yes: Check for kinked, or blocked incoming water hoses, clean the incoming water screens. If the problem remains, replace the water inlet valve assembly.
No: correct Pressure Problem.
Step 4: Does the washer continually fill with water?
Yes: go to step 5.
No: Replace the water level pressure sensor switch.
Step 5: Does water stop entering the washer when you unplug the machine?
Yes: Replace the water level pressure sensor switch.
No: Replace the water inlet valve assembly.
Step 6: If the steps above did not fix the error, replace the control board.
The replacement parts for this error are listed below if you end up needing the control board, which is not very common, but in the case you do, and you need the part number write us for it in chat as we will need your full model number to give you that information.
Frigidaire Affinity Washer Water Inlet Valve
Frigidaire Affinity Washer Water Level Pressure Sensor Switch
