WHIRLPOOL CABRIO WASHER ERROR F7E6
The Cabrio Washer F7E6 error code means the main board has detected one or more of the motor lines open. Motor circuit loss of phase.
- Reset the washer by unplugging the washer for 5 minutes then plug it back in and see if the error persists. If the error quits and the washer is working after the reset then the main board just needed a hard reset.
- If it did not reset then check the wiring harness plug at the motor for a proper connection.
- If the plug and wiring looks ok then there are some diagnostic tests that can be made with an ohm/volt meter. If you need help with this error code let us know.
If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F7E6 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F7E6 Repair Guide.
This error code applies to the models below in the tag section and many more.
