WHIRLPOOL CABRIO WASHER ERROR F1E2
The Cabrio Washer F1E2 error code indicates a main control failure in the motor control circuit.
- Unplug the washer for five minutes, plug it back in and see if the board resets.
- If the reset above did not work and the error persists unplug it again remove the back panel from the console and check all the wiring and make sure all the connections are tight and secure and that there are not any broken wires. Also check the wiring harness at the stator (motor).
- If the wiring checks out ok then the board will have to be replaced, there are some diagnostic steps you can take to verify its the board at fault if you have a ohm/volt meter.
If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F1E2 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F1E2 Repair Guide.
This error code applies to the models below in the tag section and many more.
