WHIRLPOOL CABRIO WASHER ERROR F5E4
The Cabrio Washer F5E4 error code means the washer lid was not raised between cycles.
- This error can happen if you did not raise the lid on the washer and started a new cycle. It can also occur if you pressed the start cycle button with the lid open.
- It can also come up when the main control board can’t determine if the lock assembly is in the locked or unlocked state, in most cases this means the lid lock assembly has failed. In some cases it can be the main board at fault, this is not very common but can happen.
- There are some diagnostic steps you can take with an ohm/volt meter to determine the cause of the failure if you need help with these steps let us know.
If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F5E4 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F5E4 Repair Guide.
This error code applies to the models below in the tag section and many more.
