December 12, 2024

Cabrio Washer error f36

Whirlpool Cabrio Washer Error F36

The Cabrio Washer F36 error happens when the main control detects failed communications between the central control unit (CCU) and the user interface (UI). The steps to take to try and fix this error are listed below:

  1. Unplug the washer and remove the rear panel on the console to access the main control board.
  2. Make sure that the P7 plug is properly connected to the board, even if it looks ok unplug it and reinsert it to ensure a good connection.
  3. Plug the washer back up, press power/cancel, wash cycle normal, power/cancel, if the washer starts and updates the 7 segment display then communication has been restored and the washer should be fine.
  4. If the error persists replace the user interface board, if the (UI) has already been replaced then replace the main control board.

If you need the specific diagnostic steps to take for the Whirpool Cabrio Washer Error F36 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F36 Repair Guide.

This error code applies to the models below in the tag section and many more.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.