March 1, 2024

Cabrio Washer Error F4E1


The Cabrio Washer F4E1 error code means the heater is stuck on when it should be off.

  1. You will need to check resistance of the heater, if it is infinite its bad replace it.
  2. If the heater is ok then check the connection at the main board and make sure its connected to the board properly. It’s the J5 connector on the main board.
  3. If the connection is good and the wiring is ok then replace the main control board.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F4E1 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F4E1 Repair Guide.

This error code applies to the models below in the tag section and many more.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.