WHIRLPOOL CABRIO WASHER ERROR F5E1
The Cabrio Washer F5E1 error code means the lid switch is in a locked state but the lid switch is open.
- This error can happen if for some reason the start button wash pushed with the lid raised.
- This can also happen if the control can’t tell if the lock assembly is in the locked or unlocked state and usually means the lock assembly has failed and needs replacing, in some cases the control board can be at fault.
- There are some diagnostic steps you can take with an ohm/volt meter to figure out the issue, if you need help with this error let us know.
- If you don’t have access to an ohmmeter or don’t know how to use one just replace the door lock assembly because that is normally what causes this error. The door lock assembly for these models is linked below.
WHIRLPOOL W10810403 WASHER LID LOCK LATCH ASSEMBLY
Whirlpool W10810403 Washer Lid Lock Latch Assembly – Ensure the safety and proper functioning of you…
If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F5E1 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F5E1 Repair Guide.
This error code applies to the models below in the tag section and many more.
