June 22, 2024

Cabrio Washer Error F7E1


The Cabrio Washer F7E1 error code means the main board has lost power during the spin cycle.

  1. Reset the washer by unplugging the washer for 5 minutes then plug it back in and see if the error persists. If the error quits and the washer is working after the reset then the main board just needed a hard reset or there was a power loss to the washer during the cycle.
  2. If the reset did not help then check your breaker box / fuse panel and check the wall plug the washer is plugged into and verify proper voltage to the washer.
  3. If proper voltage is verified at the wall outlet then check the power cord on the washer and make sure its not burned or cut anywhere.
  4. If the plug and wiring looks ok then there may be a main board failure, there are some diagnostic tests that can be made with an ohm/volt meter. If you need help with this error code let us know.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F7E1 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F7E1 Repair Guide.

This error code applies to the models below in the tag section and many more.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.