December 12, 2024

Cabrio Washer Error F8E6

WHIRLPOOL CABRIO WASHER ERROR F8E6

The Cabrio Washer F8E6 error code happens when the main control detects water in the tub when the lid is open, meaning the water inlet valve is likely letting water in the tub when it should not be. This considered a Water Hazard Condition.

  1. Check the water level pressure switch hose from the tub to the main control for kinks, pinches or tears, also make sure its connected properly to the main control.
  2. Turn the power to the machine off or unplug it, does water still enter the machine? If so the water inlet valve has failed and needs to be replaced.
  3. If all the above looks ok then there are tests that can be made with an ohm/volt meter, but most likely the water pressure level switch sensor on the main board has failed and the board will have to be changed out to repair the washer.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F8E6 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F8E6 Repair Guide.

This error code applies to the models below in the tag section and many more.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.