December 12, 2024

Cabrio Washer error f41

Whirlpool Cabrio Washer Error F41

The Cabrio Washer F41 error happens when the main control detects that the motor rotor position sensor (RPS) has a shorted or open thermistor, some things you can do to try an fix this error are listed below:

  1. Spin the basket by hand and see if it spins freely, if not then there is some kind of mechanical friction stopping the basket from spinning properly.
  2. Remove the back of the console and check the P5 and P10 connectors on the main board, makes sure they are properly seated in the board and that the wires are not broken or burned. Unplug P5 and P10 and plug them back in.
  3. Try and run a cycle and if the error persists then there are some diagnostic steps you can take using an ohm/volt meter, if you have a meter and would like to do these tests let us know and a tech can help you in live chat.

In most cases the problem is caused by a failed RPS Sensor.

The RPS Sensor Can Be Purchased From The Link Below

Cabrio RPS Sensor

If you need the specific diagnostic steps to take for the Whirpool Cabrio Washer Error F41 see our guide:

HOW TO TROUBLESHOOT WHIRLPOOL CABRIO WASHER MOTOR CIRCUIT

This error code applies to the models below in the tag section and many more.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.