December 12, 2024

Cabrio Washer Error F9E2

WHIRLPOOL CABRIO WASHER ERROR F9E2

The Cabrio Washer F9E2 error code happens when the main control detects the water in the tub is not draining at all, this is consider a pump drive system failure.

  1. Check the water level pressure switch hose from the tub to the main control for kinks, pinches or tears, also make sure its connected properly to the main control.
  2. Can you hear the pump motor running? If so unplug the washer and pull the tub to pump hose off and look for any blockage in the line. Pull the pump motor off and check it for any trash that may have be causing it to drain slow. If the issue continues and you followed the steps above and you are certain the pump is getting voltage from the main control replace the water pump.
  3. If all the above looks ok then there are tests that can be made with an ohm/volt meter to determine the cause of the problem and/or verify a faulty pump motor or main board issue.

If you need the specific diagnostic steps to take for the Whirlpool Cabrio Washer Error F9E2 then click on the live tech help button at the bottom right of the page and let one of our technicians help you in live chat. You can also  visit our Tech Help Service Center and order a Custom Whirlpool Cabrio Washer Error F9E2 Repair Guide.

This error code applies to the models below in the tag section and many more.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.